Headlight Bulb Replacement

A WARNING

- Halogen headlight bulb becomes very hot while the headlight is ON. and remains hot for a while after it is turned OFF. Be sure to let it cool down before servicing.

CAUTION___

■ Wear clean gloves while replacing the bulb. Do not put finger prints on the headlight bulb, as they may create hot spots on the bulb and cause it to break.

• If you touch the bulb with your bare hands, clean it with a cloth moistened with alcohol to prevent its early failure.

Be sure to install the dust cover after replacing the bulb. __

Remove the tapping screws and release the claws of the cowl lower caver from the front cowl stay.

Remove the front cowl lower cover.

Disconnect the headlight bulb socket and remove the rubber cover.

Release the bulb retainer and remove the headlight bulb.

Install a new bu lb and the removed parts in the reverse order of removal.

(3) RETAINER

(1) BULB SOCKET

(2) RUBBER COVER

(4) BULB

(3) RETAINER

(1) BULB SOCKET

(2) RUBBER COVER

Combination Meter Bulb Replacement

Procedure

Q'ty

Remarks

Removal Order

Installation is in the reverse order of removal

(1}

Speedometer cable

1

Disconnect the cable at the speedometer gear box.

(2)

Meter mounting bolt

3

(3)

Collar (short)

2

Lift the combination meter and pull over the rubber cover so

that you can remove the bulb socket.

(4)

Collar (long)

1

(5)

Bulb socket/Bulb

1 1/11

Combination Meter Removal/Installation

Requisite Service

■ Wind screen removal/installation (page 2-4)

Procedure

Q'ty

Remarks

Removal Order

Installation is the reverse order of removal.

(1)

Meter mounting bolt

3

(2)

Collar (short)

2

(3)

Collar (longl

1

(4)

Speedometer cable

1

Disconnect the speedometer cable at the speedometer gear box side, if necessary disconnect the cable from the meter afar detaching the meter from the front cowl stay.

(5)

Rear view mirror inner cover

2

(6)

9P mini connector

1

(7)

6P mini connector

1

(81

Meter assembly

1

Combination Meter Disassembly/Assembly

Requisite Service

■ Combination meter removal/installation (page 18-5)

Procedure

Q'ty

Remarks

Disassembly Order

Assembly is in the reverse order of disassembly.

(1)

Wire clamp

1

Install each bulb socket referring to the wire color code

(2)

Butb socket

11

stamped on the meter case.

(3)

Wire terminal

5

(4)

Reset knob

1

(5)

Meter cover screw

6

(6)

Coolant temperature gauge

1

NOTE

■ Before assembling the meter case and meter cover, temporarily secure the coolant temerature gauge with the wire ternminal screws.

• When securing the coolant temperature gauge with the wire terminals, tighten the terminal screws with the meter facing up.

(7)

Meter lens

1

(8)

Indicator lens (Neutral/Turn signal)

1

(9)

Indicator lens (High beam/Oil temperaiure/ Turn signal)

1

(10

Screw

3

(11

Rubber cover retainer

1

Align the four holes in the rubber cover with the pins on the meter cover.

(12

Rubber cover

1

(13

Screw

2

(14

Tachometer

1

(15

Screw

2

(16

Speedometer

1

Was this article helpful?

0 0

Post a comment