Removalinstallation

Remove the fuel tank (page 2-3).

California type Remove the evaporative emission (EVAP) purge only: control valve from the air cleaner housing.

Remove the wire harness clip from the air cleaner housing.

Be careful not to Disconnect the four vacuum tubes and secondary break the plastic air supply hose (California: No. 15). plugs.

HARNESS CLIP

VACUUM TUBES

HARNESS CLIP

VACUUM TUBES

Air Supply Control

AIR SUPPLY HOSE

EVAP PURGE CONTROL VALVE

AIR SUPPLY HOSE

EVAP PURGE CONTROL VALVE

Disconnect the crankcase breather hose from the air cleaner housing.

Loosen the two connecting tube band screws of the air intake ducts.

BAND,SCREW

BAND,SCREW

Disconnect the crankcase breather hose from the air cleaner housing.

Loosen the two connecting tube band screws of the air intake ducts.

Loosen the four connecting tube band screws. Remove the air cleaner housing off the carburetor intake ports and air intake ducts.

Disconnect the float chamber inner air vent hose (California: No, 7) and the vacuum chamber air vent hose.

Installation is in the reverse order of removal.

Disconnect the float chamber inner air vent hose (California: No, 7) and the vacuum chamber air vent hose.

Installation is in the reverse order of removal.

5-1A

Was this article helpful?

0 0

Post a comment