Battery

EZ Battery Reconditioning Method

Recondition  All Batteries

Get Instant Access

REMOVAL/INSTALLATION

Remove the seat (pege 2-2). NOTE

Always turn the ignition switch OFF before removing or installing the battery.

Remove the battery cover bolts and cover.

Remove the battery positive cable cover.

Disconnect the battery negative cable first, then the positive cable from the battery.

Remove the tool kit and the battery.

Installation is in the reverse order of removal.

NOTE

Apply clean grease to the battery terminals. Pull the cover over the positive terminal.

VOLTAGE INSPECTION

Measure the battery voltage using a digital multimeter.

Voltage: Fully charged: Over 13.0 V

Under charged: Below 12.3 V

Tool:

Digital multimeter

Commercially available

BATTERY CHARGING

à warming

• The battery gives off explosive gases; keep sparks, flames, and cigarettes away. Provide adequate ventilation when charging.

•The battery contains sulfuric acid (electrolyte). Contact with skin or eyes may cause severe burns. Wear protective clothing and a face shield.

- If electrolyte gets on your skin, flush with water.

- If electrolyte gets on your eyes, flush with water for at least 15 minutes and call physician.

• Electrolyte is poisonous. If swallowed, drink large quantities of water or milk and follow with milk of magnesia or vegetable oil and call a physician.

• Turn power ON/OFF at the charger, not at the battery terminals.

(2) POSITIVE CABLE

(2) POSITIVE CABLE

Sunny Cascadeur

(1) NEGATIVE CABLE

(1) NEGATIVE CABLE

Remove the battery.

Connect the charger positive (+•> cable to the battery positive (+) terminal.

Connect the charger negative (-) cable to the battery negative (-) terminal.

-----

Standard

Quick

Charging current

0.9 A

4.0 A

Charging time

5 hours

• Quick-charging should only be done in an emergency; ' slow charging is preferred.

• For battery charging, do not exceed the charging current and time specified on the battery. Using excessive current or extending the charging time may damage the battery.

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment