Clutch System

Measure the clutch free play at the end of the Clutch lever. Free play: 10 - 20 mm (3/8 - 3/4 in)

(1) REAR BRAKE LIGHT SWITCH

f<2> ADJUSTING NUT

(1) HORIZONTAL

(2) VERTICAL

(1) HORIZONTAL

(2) VERTICAL

Adjust as follows:

Minor adjustments are made at the adjuster near the lever. Loosen the lock nut and turn the adjuster. Tighten the lock nut.

CAUTION

• The adjuster may be damaged if it is positioned too far out, leaving minimal thread engagement.

If the adjuster is threaded out near its limit and the correct free play cannot be obtained, turn the adjuster all the way in and back out one turn. Tighten the lock nut and make a major adjustment as described below.

Major adjustment is performed at the clutch arm. Remove the left side fairing {page 2-3).

Loosen the lock nut and turn the adjusting nut to adjust free play. Hold the adjusting nut securely while tightening the lock nut.

If proper free play cannot be obtained, or the clutch slips during the test ride, disassemble and inspect the clutch (see section 9).

Install the left side fairing in the reverse order of removal.

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment