Evap Cav Solenoid Valve California type Operation Check

EZ Battery Reconditioning Method

Recondition Old Batteries

Get Instant Access

Disconnect the No.4, 8 tubes from the EVAP CAV solenoid valve.

Connect the pressure pump to the No.4 tube fitting goes to EVAP canister.

Tool:

CAUTION

• Damage to the air vent solenoid valve may result from use of high pressure air source. Use a hand operated air pump only

IGNITION SWITCH OFF: {1> N0 4 TUBE fitting

IGNITION SWITCH OFF: {1> N0 4 TUBE fitting

1996 Honda Cbr 600Evap Canister Vent Valve SolenoidSolenoid Engine Plans

(1) AIR VENT SOLENOID CONNECTOR

SOLENOID VALVE RELAY

With the ignition switch OFF, pump air through the No.4 tube fitting goes to air vent solenoid valve.

Connect the pressure pump to the No.8 tube fitting. With the ignition switch ON, pump air through the No.4 tube fitting goes to air vent solenoid valve.

Cbr 600 Ignition Wiring

EVAP CAV SOLENOID VALVE VOLTAGE

Disconnect the air vent solenoid valve connector. Turn the ignition switch ON and measure the voltage between the connector terminals of the wire harness.

Connection: Black (+) - Green (-) Standard: Battery voltage

AIR VENT SOLENOID VALVE (California type) OPERATION CHECK

Remove the drive sprocket from the counterstaft (page 7-3).

a warning

• Never inspect while drive sprocket is instaling.

Disconnet the No.4, 6, 7 tubes from the air vent solenoid valve.

Connect the pressure pump to the No.4 tube fitting. Tool:

CAUTION

• Damage to the air vent solenoid valve may result from use of high pressure air source. Use a hand operated air pump only.

Connect the pressure pump to the No.4 tube fitting. Start the engine then shift the transmission into gear. With the speedometer below 12 mph (20 km/h), pump air through the No.6 tube fitting.

BELOW 12 mph (20 km/h):

^-(1) No.6 TUBE FITTING

% J

(2) No.4 TUBE FITTING

(3)

PRESSURE PUMP

(1) EVAP CAV SOLENOID VALVE CONNECTOR

(1) DRIVE SPROCKET

Connect the pressure pump to the No.7 tube fitting. Start the engine then shift the transmission into gear. With the speedometer above 12 mph {20 km/h), pump air through the No.6 tube fitting.

Where Connect Carburetor Solenoid

AIR VENT SOLENOID VALVE RELAY (California type)

AIR VENT SOLENOID VALVE RELAY VOLTAGE

Remove the upper fairing (page 2-4).

Check for loose or poor connection of the connector.

Turn the ignition switch ON and measure the voltage between the connector terminals at the air vent solenoid valve relay connector.

Connection: Orange/Black (+) - ground (-) Standard: Battery voltage

Connection: Black 1 (+) - ground (-) Standard: Battery voltage

Connection: Black 2 (+) - ground {-) Standard: Battery voltage

(1) AIR VENT SOLENOID VALVE RELAY

(1) AIR VENT SOLENOID VALVE RELAY

Honda Cbr 600 Del 2000

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment