Fuel Pump

EZ Battery Reconditioning Method

Battery Repair Ebook

Get Instant Access

SYSTEM INSPECTION

Turn the ignition switch OFF.

Remove the side cover (page 2-2) and disconnect the fuel cut-off relay connector.

Check for battery voltage between the Black (+) terminal and ground (-).

There should be battery voltage with the ignition switch ON.

If there is no voltage, check for an open circuit or loose connection in the Blue/Yellow wire.

If there is battery voltage, check for continuity in the Black/ Blue wire.

Check for continuity, between the Black/Blue wire and ground.

THERMOSENSOR

Starting Circuit Cutoff Relay Yamaha

(1) FUEL CUT-OFF RELAY

2000 Honda Cbr 929 Fuel System Diagram

(1) JUMPER WIRE

(1) FUEL PUMP CONNECTOR

If there is continuity, replace the fuel cut-off relay.

If there is no continuity, short the Black and Black/Blue terminals at the relay connector with the suitable jumper wire.

Disconnect the fuel pump 2P (Black) connector and check for battery voltage between the Black/Blue {+) and Green <-) terminals with the ignition switch ON.

If there is battery voltage, replace the fuel pump.

If there is no battery voltage, check for an open circuit or loose connection in the Black and Green wires.

DISCHARGE VOLUME INSPECTION

• Gasoline is extremely flammable and is explosive under certain conditions. Work in a well ventilated area with the engine off. Do not smoke or allow flames or sparks in the work area or where gasoline is stored.

Disconnect the fuel cut-off relay connector and short the Black and Black/Blue terminals with a suitable jumper wire {see page 18-5).

Remove the right side cover (page 2-2) and disconnect the fuel tube from the tube joint. Hold a graduated beaker under the fuel tube.

Turn the ignition switch ON and let the fuel flow into the beaker for 5 seconds, then turn the ignition switch OFF.

Multiply the amount in the beaker by 12 to determine the fuel pump flow capacity per minute.

Fuel pump flow capacity:

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Responses

  • phyllis williams
    How to wire a ignition to the fuel pump on a 96 cbr 600?
    4 years ago

Post a comment