Cylinder Head Removal

Drain the coolant (page 6-5).

Remove the following: - Camshaft (page 8 6)

Thermostat housing (page 6-6)

Remove the cylinder drain bolt and sealing washer. Drain the coolant from the cylinder head and cylinder block.

Check the scaling washer is in good condition, replace if necessary.

Reinstall the sealing washer and drain bolt.

Remove the socket bolts, sealing washers and cam chain tensioner lifter and gasket.

Loosen the y mm bolts in a crisscross pattern in two or three steps.

Remove the two 6-mm flange bolts. Remove the ten 9-rnm bolts,/washers.

Remove the cylinder head.

Remove the gasket and dowel pins.

Cylinder Block Drain Coolant

CYLINDER DRAIN BOLT/SEALING WASHER

SEALING WASHERS

TENSIONER LIFTfR

SOCKET BOLTS

GASKET

9 mm BOLTS

6 mm BOLTS

9 mm BOLTS

DOWEL PINS

Cbr600 Bolt Rotor

GASKET

DOWEL PINS

GASKET

Cbr600 F4i Vacuum Diagram

CAM CHAIN

Remove the cam chain and timing sprocket from the crankshaft.

Remove the right crankcase cover and ignition pulse generator rotor (page 17 7).

Remove the socket bolt, washer, cam chain guide and collar.

Remove the socket bolt, cam chain tensioner and washer.

b mm

Top Timing Cam Cbr

TOP VIEW

25 mm I D. (when compressed)

15 mm

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Responses

  • JORDAN
    How to pull f4i cylinder head?
    6 years ago
  • nebyat
    How remove cbr f4i cylnder head?
    5 years ago

Post a comment