Cylinder Inspection

Inspect the cylinder bore for wear or damage. Measure the cylinder I.D. in the X and Y axes at three levels.

Take the maximum reading to determine the cylinder wear.

SERVICE LIMIT: 67.10 mm (2.642 in)

Calculate the piston-to-r.ylinder clearance.

Take a maximum reading to determine the clearance.

Refer to page 11-5 for measurement of the piston O.D.

SERVICE LIMIT: 0.10 mm 10.004 in)

Calculate the taper and out of round at three levels in the X and Y axes, Take the maximum reading to determine them.

SERVICE LIMITS: Taper: 0.10 mm (0.004 in)

The cylinder must be rebored arid an oversize piston fitted if the service limits are exceeded.

The following oversize piston is available: 0.25 mm (0.010 in)

The piston to cylinder clearance for the oversize pis ton must be: 0.015 - 0.050 mm (0.0006 - 0.0020 in).

Inspect the top of the cylinder for warpage.

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment