Info

SEALING WASHER SOCKET BOLT

Hold the axle holder in a vise with soft jaws or a shop towel.

If the fork damper Tighten the fork socket boll to the specified torque.

turns together -

with the socket TORQUE: 34 N-m (3.5 kgf-m. 25 lbf-ft)

boll temporarily install the fork spring, spring sesi cellar and tcrk bolt.

Pour the specified amount of the recommended fork fluid into the fork tube.

RECOMMENDED FORK FLUID:

Pro Honda Suspension Fluid SS-8 FORK FLUID CAPACITY:

462 ± 2.5 cm3 (15.6 ± 0.08 US oz, 16.3 x 0.09 Imp oz)

Pump the damper rod several times until the fork fluid flows out of the oil hole in the rebound damping adjuster.

Slowly pump the fork tube several times to remove the trapped air.

Compress the fork tube slowly.

Make sure the oil Measure the oil level from the top of the fork tube.

level is the same in the both forks. FORK OIL LEVEL: 116 mm (4.6 in)

Pull the damper rod up and install the fork spring with the tapered end facing up.

Remove the following:

- Spring seat

- Spring collar

- Spring joint plate

* FORK SPRING

* FORK SPRING

Install a new O-ring onto the fork bolt. Apply fork fluid onto the new O-ring.

Screw the fork bolt into the rebound adjuster until it seats.

Hold the rebound adjuster with a 17-mm spanner and tighten the fork bolt.

PLATE

FORK BOLT

PLATE

Screw the fork bolt into the fork tube.

Install the fork protector.

FORK BOLT

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment