Installation

Connect the throttle cable ends to the throttle pipe.

Apply grease to the sliding surface of the throttle RIGHT HANDLEBAR

pipe.

Install the throttle pipe into the right handlebar.

THROTTLE PIPE

THROTTLE PIPE

Install each handlehar onto the fork tube, aligning its boss with the groove in the fork top bridge.

HANDLEBAR STOPPER PIN

HANDLEBAR STOPPER PIN

TOP RRIDGL GROOVE

Tighten the handlebar pinch bolts securely. Install the stopper ring into the fork tube groove.

HANDLEBAR PINCH BOLI jr STOPPER RING

Apply lubricant spray through the tab locking hole and onto the ruhher for easy removal.

HANDLEBAR WEIGHT REPLACEMENT

Remove the grip from the handlebar.

Straighten the weight retainer tab with a screwdriver or punch.

Temporarily install the grip end and screw, then remove the handlebar weight by turning the grip end.

RETAINER RING

RETAINER TAB

RETAINER RING

RETAINER TAB

RUBBER

CUSHION

RUBBER

CUSHION

INNER WEIGHT

RETAINER HOLE

INNER WEIGHT

RETAINER HOLE

Remove the grip end from the handlebar weight. Discard the retainer.

Install the new retainer onto the handlebar weight. Install the grip end onto the handlebar weight aligning its boss with the slot in the handlebar weight. Install a new mounting screw.

INNER WEIGHT

INNER WEIGHT

HANDLEBAR WEIGHT

¬ęSi RETAINER RING

HANDLEBAR WEIGHT

Insert the handlebar weight assembly into the handlebar.

Turn the handlebar weight and hook the retainer tab with the hole in the handlebar.

RETAINER TAB

RETAINfR RING

RETAINER RING VZ

RETAINER TAB

RETAINfR RING

RETAINER RING VZ

INNER WEIGHT

HANDLEBAR WEIGHT

INNER WEIGHT

HANDLEBAR WEIGHT

Apply Honda Bond A or Honda Hand Grip Cement (U.S.A. only) to the inside of the grip and to the clean surfaces of the left handlebar and throttle grip.

Allow the adhesive to dry for 1 hour before using.

Wait 3-5 minutes and install the grip.

Rotate the grip tor even application of the adhesive.

Install the left handlebar switch housing aligning its locating pin with the hole in the handlebar.

Tighten the forward screw first, then the rear screw.

Install the clutch lever bracket assembly by aligning the end of the bracket with the punch mark on the handlebar.

Install the clutch lever bracket holder with the "UP" mark far.ing up.

Tighten the upper bolt first, then the lower bolt. Connect the clutch switch wire connectors.

HOLDER LEVER BRACKET

HOLDER LEVER BRACKET

HOLE SWITCH HOUSING

HOLE SWITCH HOUSING

SWITCH HOUSING

SWITCH HOUSING

Install the right handlebar switch,throttle housing by aligning its locating pin with the hole in the handlebar.

Tighten the forward screw first, then the rear screw.

Install the master cylinder by aligning the end of the master cylinder with the punch mark on the handlebar. Install the master cylinder holdei with the "UP" mark facing up.

Tighten the upper bolt first, then the lower bolt. TORQUE: 12 N-m (1.2 kgf-m, 9 lbf-ft)

Connect the brake switch wire connectors.

Install the grip end and tighten the new mounting screw to the specified torque.

SWITCH HOUSING

THROTTLE PIPE

HOLE

SWITCH HOUSING

THROTTLE PIPE

HOLE

MASTER CYLINDER

"UP" MARK

BOLTS

MASTER CYLINDER

"UP" MARK

BOLTS

Body Language

Body Language

Is a handshake really just a mere handshake, or does it express so much more? Discover Body Language and How it Can Benefit You. You will never be in the dark again on a persons mood when you can read their body language!

Get My Free Ebook


Post a comment