Piston Installation

Apply molybdenum oil solution to the connecting rod small end inner surfaces and piston pin outer surfaces.

Install the pinion Install the piston pin into the piston and connecting so the "IN" mark rod.

faces the same direction as the oil hole in the con necting rod


Install new piston pin clips are into the grooves of the piston pin hole.

• Make sure that the piston pin clips seated securely.

• Do not align the piston pin clip end gap with the piston cut-out.


Install the piston/connecting rod assembly with the piston "IN: mark facing tn the intake side.

Apply engine oil to the cylinder wall, piston and pis ton rings.

Install the piston/connecting rod assembly into the cylinder using a commercially available piston ring compressor tool.

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook

Post a comment