Removal

Remove the following:

Release the bosses from the rear fender, then remove the battery tray cover.

Unhook the retaining tab and remove the PGM Fl fuse case and fuse box.

Remove the starter relay switch from the rear fender boss.

PGM-n FUSE CASE FUSE BOX

PGM-n FUSE CASE FUSE BOX

Disconnect the following connectors:

- Rear turn signal connectors

- License light connector Tail/brake light connectors

Unhook the seat lock cable from the cable stay.

TAIL/BRAKE LIGHT CONNECTORS

TAIL/BRAKE LIGHT CONNECTORS

SEAT I OCK CABLE

LICENSE LIGHT CONNECTOR TURN SIGNAL CONNECTORS

Remove the fuel cut-off relay and engine stop relay from the rear fender bosses.

Release the rear sub-harness from the rear fender wire guides.

BATTERY I HAY COVER

BATTERY I HAY COVER

FUEL CUT-OFF RELAY

STOP RELAY

SUB-HARNESS

FUEL CUT-OFF RELAY

SUB-HARNESS

STOP RELAY

Remove the two rear tender mounting bolts and collars.

/ ti/j nOLTS/COLLARS

/ ti/j nOLTS/COLLARS

Unhook the rear fender from the seat rail brace, then remove the rear fender while moving il back.

REAR FENDER

SEAT RAIL BRACE

REAR FENDER

SEAT RAIL BRACE

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment