Right Crankcase Cover Installation

Apply a sealant to the mating surfaces of the crankcase as shown.

Apply sealant to the mating surface of the right crankcase cover.

Install the two dowel pins.

Install the right crankcase cover while turning the lifter arm clockwise to engage the lifter arm groove with the lifter piece flange.

Connect the clutch cable end to the clutch lifter lever, then install the clutch cable bracket with the two bolts.

Tighten the four holts first in the numerical order cast on the right crankcasc cover in two or three steps.

Tighten the the other cover bolts crisscross pattern in two to three steps.

¡\ i, ■ _ (m

Connect the ignition pulse generator 2P <Rcd) con nector.

Pour the recommended engine oil (poge 3 14).

Install the removed parts in the reverse order of removal.

2P (RED) CONNECTOR

2P (RED) CONNECTOR

CLUTCH CAB^

CABLE BRACKET

LEVEH

CLUTCH CAB^

CABLE BRACKET

MEMO

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment