Selfdiagnosis Reset Procedure

1.Turn the engine stop switch to "RUN" and the ignition switch to "OFF".

2. Short the service check connector of the PGM-FI system using a jumper wire.

3.Turn the ignition switch to "ON".

4. Remove the jumper wire from the service chcck connector.

5. The MIL lights about 5 seconds.

While the indicator lights, short the service check connector again with the jumper wire. Self diagnosis memory data is erased if the MIL turns off and then starts blinking.

• The scrvicc check connector must be jumped while the indicator lights. If not, the MIL will not start blinking.

• Note that the self diagnosis memory data cannot be erased if you turn off the ignition switch before the MIL starts blinking.

If the MIL blinks 20 times, the data has not been erased, so try again.

MALFUNCTION INDICATOR LAMP (MIL)

O

N-fl-R «î>

n

X

Yamaha Xvs650 Dragstar Ignition Wiring
< IGNITION

SERVICE CHECK CONNECTOR

Yamaha Wiring Harness Routing

SERVICE CHECK CONNECTOR

JUMPER WIRE

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment