Starter Valve Synchronization

• Synchronize the starter valve with the engine at the normal operating temperature and with the transmission in neutral.

• Use a tachometer with graduations of 50 rpm or smaller that will accurately indicate 50 rpm change.

Support the front end of fuel tank (page .1-4).

Remove the No.1 and No.4 vacuum hoses from the air cleaner housing.

Disconnect the pressure regulator vacuum hoses at the 3 way joint.

Connect the hoses to the vacuum gauge.

Connect the tachometer.

Cbr 600 Motor Vacuum Lines

Disconncct the PAIR air suction hoses from the reed valve covers and plug the cover.

PLUG AIR SUCTION HOSE

PLUG AIR SUCTION HOSE

Nsr 250 Engine Hose Diagram

STARTER VALVE

STARTER VALVE

VACUUM

Vacuum Hose Routing Diagram Bandit 650

VACUUM

Start the engine and adjust the idle speed. IDLE SPEED: 1,300 ±100 rpm

THROTTLE STOP SCREW

THROTTLE STOP SCREW

Change Idle Cbr 600

The No. 1 aim lei Adjust each intake vacuum pressure with the No.1

valve cannot oc cylinder.

adjusted, It is the base starter valve.

No.2 SCREW No'3 S9REW No.4 SCREW

No.2 SCREW No'3 S9REW No.4 SCREW

Carb Sync Screw

Remove the plugs and connect the PAIR air suction hoses to the reed valve covers.

PLUG AIR SUCTION HOSE

PLUG AIR SUCTION HOSE

Cbr 250 Idle Adjustment

PAIR REED VALVE COVER

Adjust the idle speed if the idle speed differs from the T-specified speed. f

IDLE SPEED: 1,300 i 100 rpm

THROTTLE STOP SCREW

THROTTLE STOP SCREW

Take Starter F4i

Remove the vacuum gauge from the vacuum hoses. Connect the pressure regulator vacuum hoses to the 3-way joint.

Connect the No.l and No.4 cylinder vacuum hose to the air cleaner housing.

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Responses

  • gerry
    How do i change to voltage regulator on cbr?
    7 years ago
  • bianca
    How to setting carburetor nsr250?
    7 years ago

Post a comment