Clutch

OInstall the spacer [A] so that the tapered side [B] faces inward.

OInstall the washer [A] so that the OUT SIDE mark faces outward.

OReplace the clutch hub nut with a new one. OHolding the clutch hub, tighten the clutch hub nut.

Special Tool - Clutch Holder: 57001-1243

Torque - Clutch Hub Nut: 135 N m (14 kgf m, 100 ft lb)

• Install the spring seat [A] and spring [B] as shown. [C] Clutch Hub

1 Install the friction plates and steel plates, starting with a friction plate and alternating them.

Was this article helpful?

0 0

Post a comment