Engine Removal Installation

Remove:

Radiator Hose Clamp [A] (Loosen) Radiator Hose [B]

Oil Cooler Water Hose Clamp [C] (Loosen) Oil Cooler Water Hose [D] Radiator Bolt [E] (Loosen) Radiator Bracket Bolt [F]

Disconnect

Crankshaft Sensor Lead Connector (see Electrical System chapter)

Stick Coil Harness Connector [A]

Remove:

Air Cleaner Housing Bolt [A] Loosen:

Throttle Body Assy Clamps Bolts #3, 4 [B] (see Fuel System (DFI) chapter)

Special Tool - Carburetor Drain Plug Wrench, Hex3: 57001-1269

Remove:

Left Radiator Cover [A] (see Cooling System chapter) Left Frame Cover [B] (see Frame chapter) Shift Lever [C] (see Crankshaft/Transmission chapter) Engine Sprocket Cover [D] (see Final Drive chapter) Radiator Hose Clamp [E] (Loosen) Radiator Hose [F]

• Pull off the connectors from the engine and free the wiring from the clamps.

OFor California Model, remove the separate.

Starter Motor Lead [A] (see Electrical System chapter) Alternator Lead Connector [B] Neutral Switch Lead Connector [C] Side Stand Switch Lead Connector [D]

Engine Sprocket (see Final Drive chapter) [E]

Coolant Reserve Tank [A] (see Cooling System chapter) Air Cleaner Housing Bolt [B] Vacuum Switch Valve Hose [C]

Vacuum Switch Valve Tube [A] Inlet Air Pressure Sensor Tube [B] Throttle Body Assy [C] OLoosen the #1,2 body assy clamps [D] and pull the throttle body out of the holders, and then remove it to the left side. Special Tool - Carburetor Drain Plug Wrench, Hex3: 57001-1269

Remove: Breather Hose End [A]

Remove: Nuts [A] Clamp Bolts [B] Exhaust Pipe Assy [C]

Was this article helpful?

0 0

Post a comment