Hose Installation

• Install the hoses and pipes, being careful to follow bending direction. Avoid sharp bending, kinking, flattening or twisting.

• Run the hoses in accordance with the Cable, Wire, and Hose Routing section in the Appendix chapter.

• Wet the internal diameter of both ends of the water hose with water or coolant and install the hose onto the pipe.

• Install the clamp [A] as near as possible to the hose end to clear the raised rib of the fitting. This will prevent the hoses from working loose.

OThe clamp screws should be positioned correctly to prevent the clamps from contacting the other parts. Torque - Hose Clamp Screws: 2.0 N-m (0.2 kgf-m, 17 in-lb)

Was this article helpful?

0 0

Post a comment