Note

Olnstall the bearings so that the marked side faces out.

• Install the bearings by using the bearing driver set which does not contact the bearing inner race.

• Press in each bearing [A] right until they are bottomed.

Special Tool - Bearing Driver Set: 57001-1129 [B]

• Replace the circlips with new ones.

• Replace the grease seals with new ones.

• Press in the grease seals [A] so that the seal surface flush [B] with the end of the hole.

OApply high temperature grease to the grease seal lips. Special Tool - Bearing Driver Set: 57001-1129 [C]

Hub Bearing Inspection

Since the hub bearings are made to extremely close tolerances, the clearance cannot normally be measured.

Was this article helpful?

0 0

Post a comment