Lockable Gas Caps

w/cQvvr tor ly 4 lote style

COME VISIT US AT OUR RETAIL STORE IN FESTUS. MO!

10 EAST MAIN STREET • FESTUS, MO 63028

BACK DAT ASS UP!

BACK DAT ASS UP!

5- Both shafts' threads were cleaned and Jason installed the AIM main gear to the mainshaft with green threadlocker using the supplied tool and, torqued it to 148 lb-ft. The heavy torque spec and green threadlocker will keep the main gear in place.

6. Drilling time! Jason taped off the exposed areas to keep the metal shavings out. Then he drilled two holes (about 1-inch deep) with the supplied drill bit into the mainshaft from the surface of the AIM main gear in order to fit...

8. After both lock pins were tightened to 8 lb-ft, Jason installed the counter boss nut onto the countershaft with green threadlocker and tightened it to 148 lb-ft.

11. Once the new oil slinger was installed, Jason was ready to mount the AIM trans cover in place but he needed to install the stock ball and ramp and retaining clip (arrow) from the stock trans cover into the new AIM Reverse Gear trans cover.

8. After both lock pins were tightened to 8 lb-ft, Jason installed the counter boss nut onto the countershaft with green threadlocker and tightened it to 148 lb-ft.

12. Once that was done, the clutch cable was attached to the AIM trans cover. Then, with the supplied gasket, the new cover was bolted in place and the shift lever was installed.

9- Then the counter gear was installed onto the counter boss nut and fit with the two provided break off keys (arrows) after aligning the grooves on the counter gear with the counter boss (shown here, the top key is already installed). With red threadlocker, Jason installed the bolt and washer to the counter boss nut and tightened it. The biggest safety feature of the Reverse Gear is the break-off keys. These brass keys are put in place to prevent damage to vital transmission components when the Reverse Gear is misused due to excessive load (i.e a reverse burnout).

12. Once that was done, the clutch cable was attached to the AIM trans cover. Then, with the supplied gasket, the new cover was bolted in place and the shift lever was installed.

0 0

Post a comment