Rocker And A Roller

5- But before mounting the new exhaust, we had to install the mounting bracket to where the swingarm meets the bottom of the frame (arrow).

9. Then we routed and plugged in the Fi2000R 02 sensors to the stock plugs located in the front (arrow) near the voltage regulator), and also in the rear (located next to the oil bag).

5- But before mounting the new exhaust, we had to install the mounting bracket to where the swingarm meets the bottom of the frame (arrow).

11. The new air filter assembly was attached to the new unit and the stock air cleaner cover was reinstalled. The install was complete at this time.

6. Once we installed new exhaust gaskets, and the mounted the stock flanges and retaining clips to the new pipes, we tightened them at the heads and also at the new mounting bracket. Then we slid the new mufflers onto the headers and tightened them down. Here is where the Power Port is located (arrow).

7. Then we installed the chrome heat shields and tightened up the heat shield clamps.

10. Once the Fi2000R was hooked up, we moved onto installing the new air cleaner assembly. We removed the entire stock air cleaner assembly. Then, we built the backing plate of the K&N assembly by attaching the new velocity stack from the rear with the provided gasket and hardware. Next, we bolted the new assembly with the provided breather bolt extensions and stock bolts to the heads.

Was this article helpful?

0 0

Post a comment