[5 Signal generator rotor bolt 25 Nm 25 kgfm 180 Ibft

• Connect the oil pressure switch lead wire.

• Pass the signal generator lead wire through the upper crank-case as shown.

Bandit Signal Generator

[5 Generator mounting bolt: 25 N-m (2.5 kgf-m, 18.0 Ib-ft)

NOTE:

Apply SUZUKI SUPER GREASE "A" to the generator O-ring. 99000-25010: SUZUKI SUPER GREASE "A"

a caution

Replace the O-ring with a new one.

• Install the starter motor

[5 Starter motor mounting bolt: 6 N-m (0.6 kgf-m, 4.5 Ib-ft)

NOTE:

* Apply SUZUKI SUPER GREASE "A" to the starter motor O-ring.

* Apply a small quantity of THREAD LOCK "1342" to the two bolts.

tffl 99000-32050: THREAD LOCK "1342"

99000-25010: SUZUKI SUPER GREASE "A"

CYLINDER BLOCK STUD BOLT LOCATION

Item No.

Length

©®@®®<0>(B>®

175 mm (6.89 in)

<D ® © ®

168 mm (6.61 in)

® Exhaust side

® Exhaust side

NOTE:

Before installing the cylinder block stud bolt (J), apply a light coat of the recommended bond to its threads.

99000-31140: SUZUKI BOND "1207B" H Cylinder block stud bolt: 15 N-m (1.5 kgf-m, 11.0 Ib-ft)

How Change Piston Rings Gsf 600

• Make sure that the oil jets © in the upper crankcase are not clogged.

• Install the pistons and piston pins in their original cylinders. Refer to the scribe marks on each piston.

• Before installing the piston pins, apply molybdenum oil solution to their surfaces.

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Responses

  • linda
    How to change piston rings gsf 600?
    8 years ago

Post a comment