General Precautions

A WARNING

* Proper service and repair procedures are important for the safety of the service mechanic and the safety and reliability of the motorcycle.

* When 2 or more persons work together, pay attention to the safety of each other.

* When it is necessary to run the engine indoors, make sure that exhaust gas is forced outdoors.

* When working with toxic or flammable materials, make sure that the area you work in is well-ventilated and that you follow all of the material manufacturer's instructions.

* Never use gasoline as a cleaning solvent.

* To avoid getting burned, do not touch the engine, engine oil, oil cooler and exhaust system until they have cooled.

* After servicing the fuel, oil, exhaust or brake systems, check all lines and fittings related to the system for leaks.

a caution

* If parts replacement is necessary, replace the parts with Suzuki Genuine Parts or their equivalent.

* When removing parts that are to be reused, keep them arranged in an orderly manner so that they may be reinstalled in the proper order and orientation.

* Be sure to use special tools when instructed.

* Make sure that all parts used in reassembly are clean. Lubricate them when specified.

* Use the specified lubricant, bond, or sealant.

* When removing the battery, disconnect the negative cable first and then the positive cable. When reconnecting the battery, connect the positive cable first and then the negative cable, and replace the terminal cover on the positive terminal.

* When performing service to electrical parts, if the service procedures not require use of battery power, disconnect the negative cable the battery.

* When tightening the cylinder head and case bolts and nuts, tighten the larger sizes first. Always tighten the bolts and nuts diagonally from the inside working out and to the specified tightening torque.

* Whenever you remove oil seals, gaskets, packing, O-rings, locking washers, self-locking nuts, cotter pins, circlips and certain other parts as specified, be sure to replace them with new ones. Also, before installing these new parts, be sure to remove any left over material from the mating surfaces.

* Never reuse a circlip. When installing a new circlip, take care not to expand the end gap larger than required to slip the circlip over the shaft. After installing a circlip, always ensure that it is completely seated in its groove and securely fitted.

* Use a torque wrench to tighten fasteners to the specified torque. Wipe off grease and oil if a thread is smeared with them.

* After reassembling, check parts for tightness and proper operation.

* To protect the environment, do not unlawfully dispose of used motor oil and other fluids: batteries, and tires.

* To protect Earth's natural resources, properly dispose of used motorcycle and parts.

SUZUKI GSF600SY (200Q-MODEL)

LEFT RIGHT

* Difference between photograph and actual motorcycle depends on the markets.

SERIAL NUMBER LOCATION

The frame serial number or V.I.N. (Vehicle Identification Number) © is stamped on the right side of the steering head pipe. The engine serial number (2) is located on the right side of the crankcase. These numbers are required especially for registering the machine and ordering spare parts.

Suzuki Bandit 600cc New Engine Parts

SERIAL NUMBER LOCATION

The frame serial number or V.I.N. (Vehicle Identification Number) © is stamped on the right side of the steering head pipe. The engine serial number (2) is located on the right side of the crankcase. These numbers are required especially for registering the machine and ordering spare parts.

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment