Ignition Coil Primary Peak Voltage

• Remove all of the spark plug caps and spark plugs.

• Connect four new spark plugs to each spark plug cap and ground them to the crankcase.

NOTE:

Make sure that all of the spark plug caps and spark plugs are connected properly and the battery is fully-charged.

Measure ignition coil primary peak voltage (for #1 and #4 cylinders) in the following procedure.

• Connect the multi circuit tester with the peak voltage adaptor as follows.

Ignition coil (for #1 and #4 cylinders): White terminal-Ground (© Probe) (© Probe)

NOTE:

Do not disconnect the ignition coil primary wire. ItSSlI 09900-25008: Multi circuit tester set

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment