More than 10 V Black Blue Yellow

If the peak voltage measured on the ignitor coupler is lower than the standard value, measure the peak voltage on the signal generator coupler as follows.

Signal Ignitor generator coupler

Signal generator

Signal Ignitor generator coupler

Signal generator

• Remove the side frame cover (left side). (CHF5-6)

• Disconnect the signal generator coupler and connect the multi circuit tester with the peak volt adaptor.

Blue terminal - Yellow terminal (© Probe) (© Probe)

• Measure the signal generator peak voltage in the same manner as on the ignitor coupler.

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment