Rectifier

Measure the continuity between the terminals © and grounds (2>. Put the tester lead on a terminal © and the other lead to ground (2). Observe the reading and then switch the leads. One of the readings should indicate continuity and the other reading should indicate infinity (no continuity). If both of the readings are the same (i.e., only continuity or only infinity (no continuity)), replace the rectifier. Perform four more tests between a terminal ©and the other terminals (Pi, P2> P3, and P4), as described above.

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment