Replace the Oring with a new one

• Install the oil seal retainer © with the four bolts and then bend the tab on the retainer.

NOTE:

Route the gear position switch lead wire to the inside of the oil seal retainer's tab ® as shown.

• Remove the grease from the tapered portion of the starter clutch and crankshaft. Use a nonflammable cleaning solvent to wipe off any oil or grease and make sure that the surfaces are completely dry.

NOTE:

Apply a small quantity of THREAD LOCK SUPER "1303" to the threads of the starter clutch mounting bolt.

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment