Signal Generator Peak Voltage

• Remove the side frame cover (left side). (d7=5-6)

NOTE:

Make sure that all of the couplers are connected properly and the battery is fully-charged.

• Disconnect the ignitor coupler © at the ignitor.

Measure the signal generator peak voltage between the YellowAA/hite and Black/Blue lead wires on the ignitor coupler.

• Connect the multi circuit tester with the peak volt adaptor as follows.

Black/Blue (© Probe) - Yellow/White (© Probe) froal 09900-25008: Multi circuit tester set

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment