Rear wheel installation

1. Install the rear wheel, axle, final gear case and drive shaft as an assembly by pushing the wheel forward and guiding the drive shaft into the middle drive shaft U-joint.

2. Install the bolts that secure the final gear case to the swingarm and tighten to the specified tightening torque.

Specified torque:

3. Insert the brake rod into the brake cam lever and install the brake pedal free play adjusting nut.

4. Install the tension bar bolt and tighten both bolts to the specified tightening torque.

5. Install panel "B".

6. Tighten the axle nut to the specified tightening torque.

7. Adjust the rear brake pedal free play. (See page 6-20.)

0 0

Post a comment