Signal System

CIRCUIT DIAGRAM

=B806000

© Main switch © Battery © Fuse (main) <35 Flasher relay <40 Turn switch <41 Hazard switch © Front turn signal light © Rear turn signal light © Fuse (signal) <60 Relay 2

SIGNAL SYSTEM CHECK

EB806023

1. If the turn signal light and/or turn indicator light fails to blink:

1. Bulb and bulb socket

► Check the bulb and bulb socket for continuity.

CONTINUITY

2. Turn switch

► Disconnect the left handlebar switch couplers from the wire harness.

►Set the hazard switch "OFF"

► Check for continuity as follows: Brown/White © - Chocolate (2) Brown/White © - Dark green

CONTINUITY

3. Hazard switch

CONTINUITY

3. Hazard switch

► Disconnect the left handlebar switch couplers from the wire harness.

►Set the turn switch "Neutral position"

► Check for continuity as follows: Brown/White © - Chocolate © Brown/White © - Dark green © Chocolate © - Dark green

Signal Xyz

NO CONTINUITY

Replace the bulb and/or bulb socket.

NO CONTINUITY

Replace the left handlebar switch.

NO CONTINUITY

Replace the left handlebar switch.

4. Voltage

• Connect the pocket tester (DC 20 V) to the flasher relay coupler.

Tester (+) lead ^ Brown terminal ® Tester (-) lead ^ Frame ground

OUT OF SPECIFICATION

►Turn the main switch to "ON". > Check the voltage (12 V) of the "Brown" ® lead at the flasher relay terminal.

MEETS

SPECIFICATION

5. Voltage

Connect the pocket tester (DC 20 V) to the flasher relay coupler.

Brown/White terminal ® Tester (-) lead ^ Frame ground

• Turn the turn switch to "L"/"R" or push the hazard switch.

• Check the voltage (12 V) on the "Brown/White" ® lead at the flasher relay terminal.

OUT OF SPECIFICATION

The wiring circuit from the main switch to the flasher relay connector is faulty, repair it.

OUT OF SPECIFICATION

The flasher relay is faulty, replace it.

n MEETS

AL SPECIFICATION

Was this article helpful?

0 0

Post a comment