Gbv

7. Verify the operation of the sensor or actuator.

• Sensor operation

The data representing the operating conditions of the sensor appears on the trip LCD.

• Actuator operation

Set the engine stop switch to "ON" to operate the actuator.

• If the engine stop switch is set to "ON", set it to "OFF", and then set it to "ON" again.

8. Turn the main switch to "OFF" to cancel the the diagnostic mode.

To perform a reliable diagnosis, make sure to turn "OFF" the power supply before every check and then start right from the beginning.

Was this article helpful?

0 0

Post a comment