Ak

Press the battery negative lead into the space between the ribs of the frame. Pass the spark plug leads #1 and #4 through the slit of the cover 2.

Pass the spark plug lead #2 through the inner hole of the cover 2.

Pass the spark plug lead #3 through the outer hole of the cover 2.

Route the spark plug lead #4 behind the air cut-off valve hose.

Point the spark plug caps of #1 to #4 to the direction as shown in the illustration. Route the spark plug lead #3 under the air cut-off valve hose.

Route the spark plug lead #2 behind the air cut-off valve hose.

I AL I Route the spark plug lead #4 by the front side of

I AM Route the spark plug leads #2 and #3 behind the air cut-off valve hose.

© Fuel pump assembly

© Fuel tank breather hose (except for CAL)

@ Fuel tank drain hose

© Charge hose (for CAL) © Roll over valve (for CAL)

[A Air opening.

[0 Install the O-ring with its lip pointed upward. O Fuel tank breather hose has a white point mark. [0 Point the knob of clip front side.

© Fuel piping connector attachment directions. (fuel pump side)

1. It is inserted until it makes a click sound the connector, and it checks that a connector does not fail out. It takes care that a foreign substance does not enter into a seal portion. (Working gloves should not be used at the time of work.)

[0 It prevents that this portion falls out.

2. The clamp is attached from the bottom after the work of "1".

It checks being completely equipped with ®, ® and C section.

except for CAL © Coolant breather hose © Coolant reservoir tank @ Coolant reservoir tank hose © Clamp

© Fuel tank drain hose

Was this article helpful?

0 0

Post a comment