Cable Routing

© Left handlebar switch lead © Main switch lead @ Clutch cable © Throttle cables © Right handlebar switch lead

[A Clamp the right and left handlebar switch leads and handlebars. Point the tip of the clamp downward in front of the handlebars.

[0 Clamp the horn lead and main switch lead to the inner tube. Point the binding section to the outside of the vehicle body and cut the tip down to the length of 1 to 5 mm (0.04 to 0.20 in).

O Route the horn lead by the headmost side.

[0 Pass the throttle cables, wire harness lead, clutch cable, main switch and immobilizer lead and left handlebar switch lead in order through the frame hole from the inner side of the vehicle.

IE Point the lead, which comes from the terminal, to the front side of the vehicle body.

Tps Location 2000 Jeep Grand Cherokee

[0 Clamp the brake hose to the inner tube. Point the binding section to the outside of the vehicle body and cut the tip down to the length of 1 to 5 mm (0.04 to 0.20 in).

[G Pass the throttle cables through the wire guide. Route the right handlebar switch lead by the outside of the wire guide.

Xvs 650 Neutral Switch

© Right handlebar switch lead © Rear brake light switch lead @ Neutral switch lead © Fuel tank breather hose © Crankshaft position sensor lead

[A Pass the right handlebar switch lead through the hole located on the right side of the frame. [0 Route the right handlebar switch lead under the bracket 2.

[C Route the coolant reservoir tank hose under the cover 2. Route the radiator hose (outside) inner side.

[0 Route the radiator hoses (2 pieces) under the cover 2.

IE Route the crank shaft position sensor lead inner side of the radiator hose.

[0 Pull down the mark-painted sections of the fuel tank breather hose, fuel tank drain hose and coolant reservoir tank breather hose to be lower than the clamp position of the muffler stay. Any order to take out the fuel tank breather hose and fuel tank drain hose can be accepted.

[G Pass the fuel tank breather hose, fuel tank drain hose, coolant reservoir tank breather hose and brake right switch lead through the guide of the stay assembly 2.

Clamp the tail brake light switch lead together with the brake fluid fluid reservoir hose.

Yamaha Fz6 Front Brake Light Switch

ED Pass the neutral switch lead between the engine and coolant reservoir tank bracket.

J To the starter motor.

[K Install the right handlebar switch lead coupler through the hole of the bracket 2 from the downside.

[0 Route the starter motor lead by the inner side of the air cut-off valve hose.

M Pass the ignition coil leads #1 and #4 through inner side of the air cut-off valve hose, and then between the frame and bracket 2.

Cbr 1000 Clutch Cable Installation

I Main switch lead © Stay assembly

@ Left handlebar switch lead @ Clutch cable © Throttle cables © Battery negative lead coupler @ Starter relay lead ® Battery negative lead @ Fuel tank drain hose @ Rectifier/regulator

II Turn signal relay

12 Radiator fan motor relay © Dimmer relay 14 Starting circuit cut-off relay © Clamp

16 License plate light lead

17 Rear turn signal light lead (right) (18 Rear turn signal light lead (left)

19 Speed sensor lead

20 Side stand switch lead

21 Oil level switch lead

22 A.C. magneto lead

(23 Throttle cable (return side)

24 Throttle cable (pull side)

25 Radiator fan motor lead

26 Oil level gauge lead

27 Sidestand switch lead A. C. magneto lead

29 Speed sensor lead

Was this article helpful?

0 0

Post a comment