Info

Point the paint marking upward.

Pass the canister hose and balance hose behind the bolt.

Pass the canister hose outside, pass the balance hose inside.

Pass the coolant reservoir tank hose hangs dowm downward from back of the bolt.

Point the knob of the clip upward. The application of water is possible at the time of attachment.

Pass the balance hose under the canister hose.

Insert this portion securely.

Spittle is turned back.

Insert to the back, but the tip of the nipple should not come out from the hose.

[K Insert the clamp certainly.

L It may open and close to direction of which. All notches gear at the time of attachment.

M Pass the coolant reservoir tank hose and the fuel tank drain hose inside of the clamp.

[N Point the knob of clamp downward.

[O Point the knob of clamp upward.

[H Insert in certainly.

[Q To the fuel tank drain tube.

Point the paint marking (both white) front side. The application of water is possible at the time of attachment.

[S Clamp the fuel tank drain hose, then the paint mark of the central part is united.

[T Air opening.

INTRODUCTION/PERIODIC MAINTENANCE CHART FOR THE EMISSION CONTROL SYSTEM/GENERAL MAINTENANCE AND

Was this article helpful?

0 0

Post a comment