Info

Route the throttle cables above the stay assy 1. Route the main switch lead above the clutch cable. Line up the left handlebar switch lead coupler and fan motor lead coupler behind the head pipe. To the main switch.

Place three couplers on the flange of the cover. To the fuel pump.

Clamp four wire leads. There should be no excessive slack on the wire leads. To the engine. To the fuel tank.

Either installation position can be accepted, but make sure that the leads are not crossed.

[K Clamp the rear turn signal lead and license plate light lead to the frame. Hook the clamp to the bracket. Pull out the lead sufficiently to the frame side and route it along with the side of the back stay. Cut the tip of the clamp to be between 1 and 5 mm (0.04 and 0.20 in) upward.

[p Clamp the rear turn signal lead and license plate light lead to the frame. Cut the tip of the clamp to be between 1 and 5 mm (0.04 and 0.20 in).

M Gap between the lead and muffler should be 10 mm (0.39 in) or more.

[N Coupler should not run on the relay assembly.

O To the tail/brake light.

[0 To the license plate light.

[Q To the rear turn signal light. (right)

[0 To the rear turn signal light (left)

[S Pass the fuel tank drain hose through the clamp located under the coolant reservoir tank.

[T Route it behind the starter motor lead.

[0 Point the bend-R section of the throttle cable (pull side) to the inner side horizontally. It is also possible to visually check the bend-R section.

W To the headlight lead.

W Point the tip of the clamp to the inner side of the vehicle body.

[X Make sure to pass the neutral switch lead through the hole of the flap.

\Y Clamp the seat lock wire to the frame as shown in the illustration. Secure the clamp to the weld of the cross member with the frame. Position the binding section in front of the vehicle body and cut the tip to be between 1 and 5 mm (0.04 and 0.20 in).

© Right handlebar switch lead © Throttle cables @ Battery positive lead © Coolant reservoir tank hose © Battery cover © Connecter cover © Fuel tank breather hose © Brake fluid reservoir hose © Lean angle cut-off switch $0 Fuse box

© Rear turn signal light lead (right) © Rear turn signal light lead (left) © License plate light lead

17 Fuel tank drain hose © Cover

(19 Starter relay lead © Battery negative lead

21 Battery negative lead coupler

22 Clutch cable © Cover 2

© Spark plug lead (25 Air cut-off valve hose

[A Either right or left side arrangement for the left handlebar switch lead coupler and radiator fan motor coupler can be accepted.

[B Point the L-shape terminal to the front side of the vehicle.

[C Hook the starter motor lead to the alternate pawls on the battery cover.

[0 Route the crank shaft position sensor lead above the starter motor leads.

IE To the crankshaft position sensor.

[0 Clamp the starter motor lead and crank shaft position sensor lead. Point the projected part of the tip to the inner side of the vehicle.

[G Pass the radiator hose, coolant reservoir hose, wire harness and starter motor lead in order through the lower side of the vehicle.

Was this article helpful?

0 0

Post a comment