This circuit is OK.
The wiring circuit from the main switch to the tail/brake light coupler is faulty and must be repaired.
3. The turn signal/position light, turn signal indicator light or both fail to blink.
1. Turn signal indicator light (LEDs)
• Check the turn signal indicator light for continuity.
Refer to "CHECKING THE LEDs".
• Are the turn signal indicator light OK?
Replace the meter assembly.
2. Turn signal switch
►Check the turn signal switch for continuity. Refer to "CHECKING THE SWITCHES". ► Is the turn signal switch OK?
Replace the left handlebar switch.
Connect the pocket tester (DC 20 V) to the turn signal relay coupler (wire harness side) as shown.
Negative tester probe Positive tester probe -
►Turn the main switch to "ON". ►Measure the voltage (DC 12 V) on brown/ green ® at the turn signal relay coupler (wire harness side).
► Is the voltage within specification?
Was this article helpful?