No

• Clean the battery terminals.

• Recharge or replace the battery.

3. Charging voltage

► Set the engine tachometer to the ignition coil of cylinder #1.

►Connect the pocket tester (DC 20 V) to the battery as shown.

Positive tester probe ^

positive battery terminal Negative tester probe ^

negative battery terminal

•Start the engine and let it run at approximately 5,000 r/min. • Measure the charging voltage.

Charging voltage 14 V at 5,000 r/min

Make sure the battery is fully charged.

• Is the charging voltage within specification?

Was this article helpful?

0 0

Post a comment