Note

• Be sure to reinstall each big end bearing in its original place.

• While compressing the piston rings with one hand, install the connecting rod assembly into the cylinder with the other hand.

• Make sure that the "Y" marks @ on the connecting rods face towards the left side of the crankshaft.

9. Tighten: • connecting rod bolts

a. Clean the connecting rod bolts.

b. Tighten the connecting rod bolts.

c. Put a mark ® on the corner of the connecting rod bolt (2 and the connecting rod (3.

d. Tighten the bolt further to reach the specified angle (120°).

e. After the installation, check that the section shown @ is flush with each other by touching the surface.

Was this article helpful?

0 0

Post a comment