Note

• Apply engine oil onto the piston pin.

• Make sure that the "Y" mark @ on the connecting rod faces left when the arrow mark ® on the piston is pointing up. Refer to the illustration.

• Reinstall each piston into its original cylinder (numbering order starting from the left: #1 to #4).

3. Lubricate:

(with the recommended lubricant)

Recommended lubricant Engine oil

Recommended lubricant Engine oil

4. Offset:

• piston ring end gaps

@ Top ring ® Lower oil ring rail © Upper oil ring rail @ 2nd ring ® Oil ring expander

5. Lubricate:

• crankshaft pins

• big end bearings

• connecting rod big end inner surface (with the recommended lubricant)

Recommended lubricant Engine oil

6. Install:

• big end bearings

• connecting rod cap (onto the connecting rod)

Align the projections on the big end bearings with the notches in the connecting rods and connecting rod caps.

► Make sure that the characters @ on both the connecting rod and connecting rod cap are aligned.

Install by carrying out the following procedures in order to assemble in the most suitable condition.

• connecting rod bolts.

a. Replace the connecting rod bolts with new ones.

Was this article helpful?

0 0

Post a comment