Caution

Before adjusting the throttle lever free play, make sure that the adjusters and locknuts on the carburetor side are fully tightened. If not, the throttle does not operate properly.

• Throttle cable flee play (a) Out of specification -> Adjust.

• Throttle cable flee play (a) Out of specification -> Adjust.

Free play: 3 ~ 5 mm (0.12 ~ 0.20 in) at throttle lever end.

2. Remove

Refer to "VALVE CLEARANCE ADJUSTMENT" section.

3. Adjust:

• Throttle cable free play **••••***##*•***••••*••**•**«***•••••

Adjustment steps: First step:

• Turn the adjuster © in or out until the specified free play is obtained.

INSP

ADJ

Turning in Free play is increased. Turning out -> Free play is decreased.

• Tighten the locknut.

If the free play cannot be adjusted here, adjust it at the throttle lever side of the cable.

Final step:

• Turn the adjuster @ in or out until the specified free play is obtained.

Turning in Free play is increased.

Turning out Free play is decreased.

> Tighten the locknut.

A WARNING

After adjusting, turn the handlebar to the right and left, making sure that the engine idling speed does not run faster.

4. Install:

INSP

MfflE1

ADJ

SPEED LIMITED ADJUSTMENT

The speed limiter keeps the carburetor throttle from becoming full-open even when the throttle lever is pushed to a maximum. Screwing in the adjuster stops the engine speed from increasing.

i

jnmjj

*••••***••*••***•*****•*•»•»•***•**•*

Adjustment steps:

• Turn the adjuster ® in or out until the proper length is attained.

Standard length: 12mm(0.47in)

• Tighten the locknut.

ik WARNING

* Particularly for a beginner rider, the speed limiter should be screwed in completely. Screw it out little by little as riding technique improves. Never remove the speed limiter from the outset.

• For proper throttle lever operation do not turn out the adjuster more then 12mm (0.47in). Also adjust the throttle lever cable play always to 3 ~ 5mm(0.12 ~ 0.20in).

Was this article helpful?

0 0

Post a comment