Chas

Install:

•Front brake disc •Disc cover (inner) •Front brake caliper •Axle nut

V

Front brake disc:

28 Nm (2.8 rrvkg, 20 ft-lb)

Front brake caliper:

28 Nm (2.8 m-kg, 20 ft-lb)

Axle nut:

85 Nm (8.5 m-kg, 61 ft-lb)

3. Install:

• Install the disc cover (Outer) © with punched burns (2) on the hub side.

4. Tighten:

5. Install:

Do not loosen the axle nut after torque tightening. If the axle nut groove is not aligned with the cotter pin hole, align groove with the hole by tightening up on the axle nut.

A WARNING

Always use a new cotter pin.

REAR WHEEL AND WHEEL HUB

(T) Wheel panel nut

SAxle nut Washer @ Wheel boss

S Drive chain Driven sprocket (7) Nut

® Sprocket boss (1) Dust cover

(0) Oil seal © Bearing © Wheel hub © Spacer ® Brake disc boss © Brake disc © Rear axle

A

TIRE SIZE:

AT22 x 10-9

B

WEAR LIMIT:

3.0 mm (0.12 in)

E Ring Nut Tightening

Apply locking agent (LOCTITE®) to ring nuts threads

1st: Tighten the inside ring nut 55 Nm (5.5 m*kg, 40 ft-lb) 2nd: Tighten the outside ring nut while holding the inside ring nut 190 Nm (19 nvkg, 140 ft-lb) 3rd: Loosen the inside ring nut while holding the outside ring nut 240 Nm (24 m«kg, 170 ft«lb)

E Ring Nut Tightening

45 l\lm (4.5 nrkg, 32 ft»lbT]

CHAS

Was this article helpful?

0 0

Post a comment