Chas

3. Apply the brake pedal and parking brake.

4. Install:

5. Tighten:

•Nuts (rear axle) (T), (2) *****************************************

Nuts tightening steps:

Before tightening the nuts, apply the LOC-TITE® to the thread portion of the rear axle.

• Finger tighten the inside nut (2) while checking the ring gear engagement.

• Tighten the inside nut with Rear axle nut wrench to specification while holding the rear axle.

Rear axle nut wrench: YM-37132

X

Inside nut (first tightening): 55 Nm (5.5 m>kg, 40 ft.lb)

• Hold the inside nut (2) and tighten the outside nut 0 with Rear axle nut wrench to specification.

190 Nm (19.0 m-kg, 140 ft-lb)

• Hold the outside nut © and tighten BACK the inside nut (2) with Rear axle nut wrench to specification.

\

Inside nut (final tightening): 240 Nm (24.0 m«kg, 170 ft.lb)

• Measure the distance 0 between lines. If distance 0 is less than 3 mm (0.12 in), retighten

BACK the inside nut. *****************************************

• Measure the distance 0 between lines. If distance 0 is less than 3 mm (0.12 in), retighten

BACK the inside nut. *****************************************

Was this article helpful?

0 0

Post a comment