Chas

From the right side •Brake disc

CAUTION:

•Never directly tap the axle end with a hammer, this will result in damage to the axle thread © and spline (2).

•Install the wheel boss (3) and suitable socket (4) on the axle end to protect the thread and spline from damage.

9. Remove:

•Driven sprocket and sprocket boss assembly •Bolts (upper wheel hub) © •Bolts (lower wheel hub) (2) •Tensioner assembly (3) •Wheel hub (4)

INSPECTION

Refer to "FRONT WHEEL- INSPECTION" section

2. Measure: •Wheel runout

Refer to "FRONT WHEEL-INSPECTION" section.

3. Inspect:

•Rear axle runout (a) Out of specification -»Replace.

Rear axle runout limit: 1.5 mm (0.06 in)

A WARNING

Do not attempt to straighten a bent axle.

Rear axle runout limit: 1.5 mm (0.06 in)

Was this article helpful?

0 0

Post a comment