Chassis

BRAKE PAD INSPECTION Front brake pad:

1. Activate the brake lever or brake pedal.

2. Inspect:

• Brake pad Wear indicator (D almost contacts brake disc-»Replace brake pad as a set.

Refer to the "BRAKE PAD REPLACEMENT" section.

Yamaha Warrior 350 Rear Brake Reservoir

Rear brake pad:

1. Depress the brake lever.

2. Inspect:

• Brake pads wear indicator (D almost contacts disc Replace pads.

Refer to the "BRAKE PAD REPLACEMENT" section.

WB2A3008

BRAKE FLUID LEVEL INSPECTION

1. Place the machine on a level surface.

2. Inspect:

• Fluid level Fluid level is under "LOWER" level line ® -»Replenish.

Recommended fluid: DOT No.4

IfDOT No4is not available. No.3 can be used

INSP

ADJ

• If DOT No.4 is not available, DOT No.3 can be used.

• When inspecting the fluid level of the reservoir at the handlebars, make sure the master cylinder top is horizontally level.

liliiiHi-

The fluid may erode painted surfaces or plastic parts. Always clean up spilled fluid immediately.

A WARNING

• Use only the designated quality fluid: otherwise, the rubber seals may deteriorate, causing leakage and poor brake performance.

• Refill with the same type of fluid; mixing fluids may result in a harmful chemical reaction and lead to poor performance.

• Be careful that water does not enter the master cylinder when refilling. Water will significantly lower the boiling point of the fluid and may result in vapor lock.

WB2A3000

FRONT BRAKE ADJUSTMENT

• Brake lever free play (a) Out of specification-Mdjust.

Free play: 4-8 mm (0.16 ~ 0.31 in) at brake lever end

Free play: 4-8 mm (0.16 ~ 0.31 in) at brake lever end

2. Adjust:

• Brake lever free play ft************************************

Adjustment steps:

• Turn the adjuster © in or out until the specified free play is obtained.

INSP

ADJ

mrm

Turning in-»Free play is increased.

Turning out-»Free play is decreased.

• Tighten the locknut.

Was this article helpful?

0 0

Post a comment