Elec

TROUBLESHOOTING

STARTER MOTOR DOES NOT OPERATE.

Procedure

Check:

1. Battery

2. Fuse

3. Main switch conduct

4. "START" switch conduct

5. "ENGINE STOP" switch conduct

6. Clutch switch conduct

7. Starter motor

8. Starter relay

9. Starting circuit cut-off relay

10. Neutral relay

11. Neutral switch conduct

12. Lever switch conduct

13. Wiring connection

•Remove the following parts before troubleshooting.

1) Seat

2) Front panel

3) Front fender

•Use the following special tools in this troubleshooting.

Pocket Tester: YU-03112

CAUTION:

To avoid damaging the CDI unit, do not test it by applying the battery voltage to it.

1. Battery

•Check the battery condition. Refer to "CHAPTER 2. BATTERY INSPECTION" section.

CORRECT

2. Fuse

• Connect the Pocket Tester (S2 x 1) to the fuse. •Check the fuse for continuity.

CONTINUITY

Refill battery fluid. Clean battery terminals. Recharge or replace battery.

Was this article helpful?

0 0

Post a comment