Elec

10. Neutral relay

»Disconnect the neutral relay (T) coupler (Green/Yellow, Brown, White/Black and Sky blue) from the wireharness.

•Connect the neutral relay coupler (Green/ Yellow (3), Brown (4), White/Black (5) and Sky blue (§)) to the Pocket Tester (i2x1) and battery (12V) (2).

Tester ( + ) Lead->White/Black (§) Lead Tester (-) Lead->Sky blue (6) Lead Battery ( + ) Lead-»Brown (4) Lead Battery (-) Lead-»Green/Yellow (3) Lead oo on

fSb

g/yJ

w/b

fix 1

►Check the neutral relay for continuity.

M [email protected]

Good Condition

Bad Condition

Battery Connected

O

O

X

X

Battery Disconnected

X

O

X

O

O: Continuity x: Discontinuity

•Connect the neutral relay coupler.

CORRECT

CORRECT

INCORRECT

INCORRECT

Replace neutral relay.

11. Neutral switch conduct

• Disconnect the neutral switch lead (Sky blue) from the wireharness.

• Connect the Pocket Tester (0 x 1) to the neutral switch lead (Sky blue 0) and engine.

Tester ( + ) Lead-»Sky blue 0 Lead Tester (-) Lead-*Engine (Ground (2))

ft X 1

î©5

J

• Shift the neutral and reverse.

• Check the neutral switch for continuity.

CORRECT

12. Lever switch conduct

•Disconnect the lever switch lead (Green/ White) from the wireharness. • Connect the Pocket Tester (fi x 1) to the lever switch lead (Green/White 0) and engine.

Tester ( + ) Lead-»Green/White 0 Lead Tester (-) Lead-*Engine (Ground (2))

INCORRECT

Transmission

Good

Bad

Position

Condition

Condition

In neutral

O

O

X

X

In gear

X

O

X

O

O: Continuity

x : Nocontinuity

•Connect the neutral switch lead.

CORRECT

INCORRECT

Replace reverse switch.

fix 1

1

►Shift the neutral and gear. ►Check the lever switch for continuity.

CORRECT

INCORRECT

Transmission

Good

Bad

Position

Condition

Condition

Forward

O

O

X

X

Reverse

X

O

X

O

O: Continuity

x : Nocontinuity

•Connect the reverse switch lead.

CORRECT

INCORRECT

13. Wiring connection

(Entire electrical starting system)

POOR CONNECTION

• Check the entire electrical starting system for connections. Refer to "WIRING DIAGRAM" section.

-J

CORRECT

CDI unit is faulty. Replace it.

ELEC

Was this article helpful?

0 0

Post a comment