Eng

1. Install: •Oil pump shaft © •Pin (|) •Inner rotor (3) •Outer rotor (4) •Oil pump housing (5) •Housing connecting screw

Housing connecting screw: 7 Nm (0.7 nvkg, 5.1 ft.lb)

Align the inner rotor mark © with the outer rotor mark (2) in the pump housing (§)• Then insert the pump shaft into the inner rotor.

2. Install:

BALANCER DRIVEN GEAR AND PRIMARY DRIVE GEAR

•Balancer driven gear (2) •Lock washer (3) •Nut (4) •Key (5)

•Balancer drive gear assembly (8) •Primary drive gear (§) •Washer © •Lock washer (Q) •Nut©

Was this article helpful?

0 0

Post a comment