J

Repair or replace spark plug.

CORRECT

2. Ignition spark gap

• Disconnect the spark plug cap from the spark plug.

•Connect the Dynamic Spark Tester (T) between the spark plug (2) and spark plug cap (3), and set the specified spark gap.

•Turn the main switch to "ON" and "ENGINE STOP" switch to "RUN", then, shift the gear in neutral. •Start the engine.

•Check the ignition spark condition.

SPARK

Ignition circuit is good.

OUT OF SPECIFICATION

3. Spark plug cap resistance

•Remove the spark plug cap. •Connect the Pocket Tester (Ox 1k) to the spark plug cap.

MEETS

SPECIFICATION

Was this article helpful?

0 0

Post a comment