insp |
tTi |
adj |
REAR SHOCK ABSORBER ADJUSTMENT
AWARNING:
Securely support the motorcycle so there is no danger of it falling over.
1. Elevate the rear wheel by placing a suitable stand under the engine.
2. Adjust:
•Spring preload
Adjustment steps: •Loosen the locknut (J). •Turn the adjuster (2) in or out.
Turning in -»Spring preload is increased.
Turning out-»Spring preload is decreased.
The length of the spring (installed) changes 1.0 mm (0.04 in) per turn of the adjuster.
Measurement length (a): Standard:
ACAUTION:
Never attempt to trun the adjuster beyond the maximum or minimum setting.
•Tighten the locknut.
Locknut:
NOTE:
When adjusting, use the special wrench and extension bar which are included in the owner's tool kit.
insp | |
adj |
WSrÊÊ |
TIRE INSPECTION
1. Measure: •Tire pressure Out of specification-»Adjust.
Was this article helpful?
Post a comment