Indicator and warning lights

1. Oil level warning light " ^zn"

2. Neutral indicator light " N "

3. Turn signal indicator light "^i i>"

4. Engine trouble warning light " hS "

5. High beam indicator light "ID"

1. Oil level warning light " ^zn"

2. Neutral indicator light " N "

3. Turn signal indicator light "^i i>"

4. Engine trouble warning light " hS "

5. High beam indicator light "ID"

EAU11020

Turn signal indicator light £>"

This indicator light flashes when the turn signal switch is pushed to the left or right.

EAU11060

Neutral indicator light " N "

This indicator light comes on when the transmission is in the neutral position.

High beam indicator light "id" This indicator light comes on when the high beam of the headlight is switched on.

EAU11120

Oil level warning light "

This warning light comes on when the engine oil level is low.

The electrical circuit of the warning light can be checked by turning the key to

If the warning light does not come on for a few seconds, then go off, have a Yamaha dealer check the electrical circuit.

Even if the oil level is sufficient, the warning light may flicker when riding on a slope or during sudden acceleration or deceleration, but this is not a malfunction.

Engine trouble warning light " "

This warning light comes on or flashes when an electrical circuit monitoring the engine is defective. When this occurs, have a Yamaha dealer check the self-diagnosis system.

The electrical circuit of the warning light can be checked by turning the key to "ON". If the warning light does not come on for a few seconds, then go off, have a Yamaha dealer check the electrical circuit.

Speedometer unit tance that can be traveled with a full tank of fuel. This information will enable you to plan future fuel stops.

Handlebar switches Left tance that can be traveled with a full tank of fuel. This information will enable you to plan future fuel stops.

1. "TRIP" button

2. Odometer/tripmeter

1. Dimmer switch "10/go"

1. "TRIP" button

2. Odometer/tripmeter

The speedometer unit is equipped with a digital odometer and a tripmeter. The speedometer shows riding speed. The odometer shows the total distance traveled. The tripmeter shows the distance traveled since it was last set to zero. Pushing the "TRIP" button switches the display between the odometer mode "ODO" and the tripmeter mode "TRIP". To reset the tripmeter, select it by pushing the "TRIP" button, and then push the "TRIP" button again and hold it down for at least one second. The tripmeter can be used to estimate the dis-

Was this article helpful?

0 0

Post a comment